The "anti-calc" cartridge is no longer functioning; replace it and then press the reset button for at least 3 seconds. Then press and hold the steam button for 2 or 3 minutes, holding the iron away from your clothes, to prime the pump.
• You have just refilled the reservoir and changed the "anti-calc" cartridge or you have just begun to use the device. ==> Press and hold the steam button for 2 or 3 minutes, keeping the iron away from your clothing to prime the pump. • The "anti-calc" cartridge is not installed or incorrectly installed in the appliance. ==> Make sure that the "anti-calc" cartridge is installed and fully engaged in its compartment. • Steam cannot be created at the temperature you have selected. ==> Adjust the thermostat to the steam zone (••• or to MAX). • The water tank is empty. ==> Fill the tank.
• You are using the steam function for the first time or you have not used the steam function in some time. ==> Press the steam button on your ironing board until the iron produces steam. • The setting is not correct (1 point/2 points) and the soleplate is not hot enough to produce steam. ==> Adjust the iron to 3 (••• or MAX) and wait for the iron thermostat light to deactivate before using the steam button again.
You did not press the reset button. Press it until the light stops flashing, then press and hold the steam button for 2 or 3 minutes, holding the iron away from your clothes, to prime the pump. If the problem persists contact an Approved Service Centre.